Saving/Calling Up PresetUsing the Effects
Presets and Banks
In preset mode, a combinaon of effects together with a
group of parameter sengs is called a “preset”. A group of
four patches is called a “bank”, and respecve presets in a
bank correspond to the footswitches.
BOOST knob (Volume Boost)
To give you a boost of extra volume when you need
it, the adjustable CTRL foot switch delivers up to
20dB of extra volume. By adjusng the boost knob
on the rear of the unit, you can preset the amount of boost
you’d like the CTRL footswitch to deliver.
Assigning the CTRL footswitch functions
Here’s how to assign the effects that will be turn
on/off by the CTRL footswitch.
1. Press the CTRL buon.
2. To select the funcon that you want to assign by
the CTRL footswitch.
REVERB:
To turn on/off the effect of reverb module.
MOD FX:
To turn on/off the effect of MOD FX module.
OD/DS BYP:
To turn on/off the effect of overdrive and distoron
instantly.
BOOST:
To turn on/off the volume boost.
The Cerberus has three operang modes: Manual mode,
Preset mode and Edit mode.
Manual mode: the tones are produced by the actual
posions of the front-panel knobs for the various effects.
Preset mode: allows you to save tone sengs and recall
them for later use.
Edit mode: take current preset to return to manual mode
temporarily so that you can use TAP tempo, CTRL and
tuner in preset.
A total of 128 presets are organized into 32 banks that you
can freely read from or write to.
Changing Among The Modes
1. Press and hold TAP footswitch to switch between
Manual mode and Preset mode.
2. Press the footswitch which is same with the current
preset leer to enter Edit mode.
3. Press and hold TAP footswitch to return to Preset mode
from Edit mode.
Manual Mode Preset Mode Edit Mode
1514
To Next Page
Loading...
Need help?
General
