nvent 910 Series - Page 22

22 | nVent.com
Table 4.7 Other Alarms Configuration Sub-Menu
L
O LOAD = {ENA or DIS}
L
O LOAD = {0.3 to 100.0} A
L
O LOAD FILTER = {0 to 12} S
H
I LOAD = {ENA or DIS}
H
I LOAD = {0.3 to 100.0} A
H
I LOAD FILTER = {0 TO 12} S
H
I GFI = {ENA or DIS}
H
I GFI = {20 to 250} mA
H
I GFI FILT ER = {0 to 12} S
G
FI TRIP = {ENA or DIS}
G
FI TRIP = {20 to 250} mA
L
O VOLT = {ENA or DIS}
L
O VOLT = {10 to 330} V
L
O VOLT FILTER = {0 to 12} S
H
I VOLT = {ENA or DIS}
H
I VOLT = {10 to 330} V
H
I VOLT FILTER = {0 to 12} S
L
O RESIST = {ENA or DIS}
L
O RESIST = {1 to 100} %
L
O RESIST FILTER = {0 to 12} S
H
I RESIST = {ENA or DIS}
H
I RESIST = {1 To 250} %
H
I RESIST FILTER = {0 to 12) S
N
OMINAL RESIST = {2.00 to 2000.00} Ω (only if LO or HI is enabled)
O
VERCURRENT TRIP = {ENA or DIS} (only if SSR is being used)
S
WITCH FAIL = {ENA or DIS}
H
TC RESET = {ENA or DIS}
C
.B. LIMITING = {ENA or DIS} (only if SSR is being used)
P
OWER LIMITING = {ENA or DIS} (only if SSR is being used)
S
WITCH LIMITING = {ENA or DIS} (only if SSR is being used)
C
ONTACTOR COUNT = {ENA or DIS} (only if Deadband or Prop Amb
Contactor are being used)
C
ONTACTOR COUNT = {0 to 999999} (only if Deadband or Prop Amb
Contactor are being used)
EEROM DATA FAIL = {ENA or DIS}
---- END ----
C
ONTROL SETPOINT = 20°C
L
O TS 1 = –10°C
L
O LOAD = 1.0 A
H
I GFI = 50 mA
G
FI TRIP = 75 mA
T
S ALARMS CONFIG…
O
THER ALARMS CONFIG…
P
OINT SETUP…
M
ISC SETUP…
C
OMMUNICATIONS SETUP…
---- END ----