nvent RAYCHEM E-100-LR-A - Step 4 A and 4 B

nVent.com | 3
BTV, QTVR
XTV, KTV
BTV, QTVR
XTV, KTV
Go to Step 5a
Go to Step 5b
5/8 in
(16 mm)
Strain
relief
1 1/4 in
(32 mm)
Do not cut
bus wires.
4A
1 1/8 in
(28 mm)
1/2 in
(13 mm)
Strain
relief
1/4 in
(6 mm)
1/4 in
(6 mm)
Do not cut
bus wires.
Skip Step 5 and go to Step 6
1/2 in
(13 mm)
1/2 in
(13 mm)
VPL
4B
• Ensure 1 1/4 in (32 mm) of
heating cable is exposed
above end seal strain relief.
• Mark heating cable jacket.
• Lightly score jacket
around and up as
shown.
• Peel off jacket.
• Determine heating cable
type and continue as
shown.
• Ensure 1 1/8 in (28 mm) of
heating cable is exposed
above end seal strain relief.
The conductor should
remain staggered.
• Lightly score jacket
around and up as
shown.
• Peel off jacket.
• Unwind heating element, cut
and remove as shown.
• Lightly score clear jacket
around and up as shown.
• Peel off jacket.
• Remove insulation from
ends of bus wires.
Note: Core sealer is not
used on VPL.
Discard core sealer.