The power cords should be standard 3-wire AC power cords including a safety ground
and rated for 16A or higher.
1. Plug in the first power cable.
2. Plug in the second power cable.
3. Wait for the System Status LED to turn green.
4. Check the System Status LEDs and confirm that all of the LEDs show status lights
consistent with normal operation as shown in the figure below. For more
information, refer to “LEDs”.
Important
The system platform will automatically power on when AC power is
applied. The system has no power switch. Check all power supplies
and fan tray modules for proper insertion before plugging in a power
cable.
Important
Complete system boot may take up to five minutes. If the
System Status LED shows amber after five minutes, unplug the
system and call your NVIDIA representative for assistance.
To Next Page
Loading...
