Nyle e360 - Tools, Materials, and Rough-In

HeatWater.com | WaterService@nyle.com | (800) 777-6953 | Rev. IM-E360-060523 HeatWater.com | WaterService@nyle.com | (800) 777-6953 | Rev. IM-E360-060523
Installation: Required Tools & Materials
18
Installation: Required Tools and Materials
In addition to all standard tools and material required for any electrical or
plumbing installation, some of the other specialty tools required to support this
installation include:
1. Heat transfer compound such as Honeywell part number 107408 or
equivalent.
2. Electrical switch lock out devices
• used to secure disconnect switches/breaker panels while servicing.
3. Electronic thermometer with range of 10°F - 210°F (-12°C - 100°C)
including:
• Sensors capable of measuring surface temperatures on water or
refrigerant piping.
• Sensors capable of measuring ambient air temperature.
4. Volt-Ohm MultiMeter - capable of measuring:
• AC Voltage up to 600 VAC.
• DC Voltage up to 24 VDC.
• Ohms up to 2,000,000 ohms.
• Continuity.
• Amperage up to 200 amps.
5. Anemometer or other airflow measuring device.
6. Magnahelic or other pressure measuring device capable of reading 0.1” to
2” w.c.g.