HeatWater.com | WaterService@nyle.com | (800) 777-6953 | Rev. IM-E360-060523
Startup Procedure
49
Startup Procedure
e-Series heat pumps must be on active power for at least 12 hours
before pressing the “On” button to enable operation. Failure to allow
this warm up time can result in damage to the compressor. Activate
both main and 120v power feeds, and ensure the system is “o” at the
control interface during this period.
The following Startup Procedure is intended to be filled out by a factory authorized
commissioning agent ONLY. This form is required to activate the unit’s warranty
and access factory tech support.
Send the completed form to waterservice@nyle.com
Before starting the Startup Procedure, ensure that the Pre-Startup
Checklist has been fully completed!
PDF Download
A standalone copy of the Startup Procedure is available here:
https://www.heatwater.com/startup-procedure-checklist/
To Next Page
Loading...
