Oce 750 - Page 6

1-4 Introduction
Introduction
Features Overview (continued)
• Output modes with Finisher or Finisher-Folder Installed:
Non-Sort, Sort, Staple-Sort, and Group modes using the primary (main) tray
Non-Sort Face Down exit, Non-Sort Face Up exit, Group Face Down exit, and
Group Face Up exit modes using the secondary (sub) tray
Stapling & Folding, and Folding modes using the booklet tray (Finisher-Folder
only)
• Output modes with Finisher / Finisher-Binder and Cover Sheet Feeder Installed:
Cover Sheet mode
Manual Staple mode
For details of each output mode, see Section 6: Output Modes.
• Power Saver
Automatically reverts to nominal optimal efficiency power after a specified period of
printer inactivity. Normal power resumes after a brief warm up period by pressing the
[POWER SAVER ON/OFF] key on the Control panel.
• Punching Mode for Finisher / Finisher-Folder with
Punching Unit Installed: Punch three holes in output prints.
• Repeat Image
Repeats the selected horizontal image area down the page as many times as permitted
by the repeat width setting (10 ~ 150mm) permits in manual or auto mode.
• Reserve
Scans subsequent print jobs while the Océ 750 is busy printing or printing.
• Resolution (400dpi, 600dpi)
400dpi and 600dpi resolution modes provide optimal image quality for photos,
complicated graphics and text requiring high to very high compression.
• Reverse Image
Reverses the image from black-on-white to white-on-black or vice versa.
• Stamp/Overlay
Imprints a stamp, watermark, or scanned image onto the print image.
• Staple
Selects the stapling position and number of staples (3 positions).