Oce 750 - Manual Stapling

6-12 Output Modes
Output Modes
Manual Stapling
The Manual Stapling function is available only with the Cover Sheet Feeder (Post
Inserter) option installed on the Finisher / Finisher-Folder. To use this function, simply
place a set of paper to be stapled into the cover sheet feeder of the finisher, select the
desired staple mode from the manual stapling operation panel located on the top of the
finisher, then press the [Staple Start/Stop] key. The stapled set will be delivered to the
Booklet tray or the Primary (main) tray according to the selected method, described
below.
When selecting stapling & folding, the machine with a Trimmer Unit trims it automatically
and delivers it to the Trimmer Unit tray.
• Stapling & Folding (2 staples in the center + Folding): Booklet tray,
or Stapling & Folding and Trimming (2 staples in the center + Folding + Trimming):
Trimmer Unit tray
• 1 oblique staple: Primary (main) tray
• 2 parallel staples: Primary (main) tray
Specifications for Manual Stapling & Folding mode
❒ Paper size: 11"x17", 8.5"x14", 8.5"x11"R, A4, A4R (8.27"x11.69", 210mmx297mm)
❒ Paper weight: 16~24 lb (20 lb paper is recommended)
❒ Staple capacity: 16 sheets max. (20 lb paper)
15 sheets max. (20 lb paper with a thick paper cover)
❒ Output tray: Booklet tray / Trimmer Unit tray
Specifications for Manual Stapling 1 oblique staple and 2 parallel staples
❒ Paper size: 11"x17", 8.5"x14", 8.5"x11", 8.5"x11"R, 5.5"x8.5", A4, A4R (8.27"x11.69",
210mmx297mm)
❒ Paper weight: 16~24 lb (20 lb paper is recommended)
❒ Staple capacity: 50 sheets max. (20 lb paper)
❒ Output tray: Primary (main) tray
MA
N
1 oblique staple
2 parallel staples
Manual stapling control panel
Stapling &
Folding
Stapling & Folding
and Trimming