Why is two-sided printing not possible on my Oce All in One Printer?
If two-sided printing is not working on your Oce All in One Printer, ensure that two-sided printing is enabled in the printer driver. Also, two-sided printing might be disabled in the administrator settings.
Why is my Oce im4512 on but not receiving data?
If your Oce All in One Printer is on but not receiving data, first ensure the USB cable is correctly connected to both the printer and your computer. If the connection is correct, verify that you've installed the appropriate printer driver. Finally, confirm that the correct printer driver is selected in your software application or that the printer is correctly registered on the network. If not, consult your network administrator.
What to do if my Oce All in One Printer stops in the middle of a print job?
If your Oce All in One Printer stops mid-print, it might be due to the exit tray being full. Remove the paper from the exit tray and try again. Also, check if the printer is out of paper and load paper if necessary.
Why can't I select my Oce im4512 from my computer?
If your Oce All in One Printer isn't being selected by your computer, ensure that the appropriate printer driver has been installed correctly. If not, install the driver.
What to do if my Oce im4512 receives data but does not print?
If your Oce All in One Printer receives data but doesn't print, it might be due to the loaded paper not matching the specified size and type. Load the correct paper, select a different paper size, or cancel the printing job.
How to fix Oce im4512 All in One Printer that prints in reverse order?
If your Oce All in One Printer prints in reverse order, the reverse page order setting might be enabled in your software application. Disable this setting in the application software to print in the correct order.
Why does transmission take a long time with my Oce im4512?
Transmission can take a long time when there is a large amount of image information, resulting in a large data file. To address this, consider adjusting your resolution and data compression settings to balance resolution and file size. For originals without photographs or illustrations, using '300x300dpi' (SCAN mode) or 'STANDARD' (INTERNET-FAX mode) will provide a workable scanned image. Higher resolution modes should be reserved for originals containing photographs when image quality is a priority, as these modes will produce larger file sizes.
What to do if the recipient does not receive data sent by e-mail (Scan to E-mail) from my Oce All in One Printer?
There are a couple of reasons why a recipient might not receive data sent via Scan to E-mail. * First, check the 'Maximum size of data attachments' setting in the administrator settings. There might be a limit set on the maximum size of image files that can be sent. This limit can be adjusted from 1 MB to 10 MB by your administrator. * Second, the mail server administrator may have set a limit on the amount of data that can be sent in one e-mail transmission. If your data exceeds this limit, even if it's within your printer's limit, the data won't be delivered. Try reducing the amount of data sent by scanning fewer pages. Consult your mail server administrator to determine the data limit for a single e-mail transmission.
Why is stapling not working on my Oce im4512?
If stapling does not occur with your Oce All in One Printer, stapling might be disabled in the administrator settings. Check with your administrator to see if "Disabling of Stapler" has been enabled. Also, verify that you are not trying to staple more than the maximum number of pages.
Why are the edges of the printed image missing on my Oce im4512?
If the edges of the printed image are missing when using your Oce All in One Printer, it could be due to the image overlapping the non-printable margins of the paper. Try adjusting the print area to fit within these margins.
General| Brand | Oce |
|---|---|
| Model | im4512 |
| Category | All in One Printer |
| Language | English |
To Next Page
