Oceanic ATOM - Page 132

132
Transmitter Battery Removal
Locate the Battery Hatch on the End of the Housing:
• Apply a coin to the recessed slot of the Hatch (Fig. 120) and
turn it counter clockwise out of the Housing.
• Remove the Battery from the Battery Compartment and
discard according to local regulations governing disposal of
batteries.
Inspection
• Closely check all of the sealing surfaces for any signs of
damage that might impair proper sealing.
• Inspect the Buttons, Lens, and Housing(s) to ensure they are
not cracked or damaged.
WARNING: If damage or corrosion is found,
return your ATOM system to an Authorized
Oceanic Dealer, and DO NOT attempt to use it
until it has received factory prescribed service.
• Remove the Battery Hatch O-ring(s) and inspect them for any
signs of deterioration or deformity. DO NOT use tools to
remove the O-ring(s).
• To ensure proper sealing, O-ring replacement is highly
recommended each time a Battery is replaced.
Fig. 120 - Transmitter Battery
Hatch