43
Fig. 37 - ATOM Battery Good
Fig. 38 - TMT3 Not Available
SYSTEM STATUS
• Depressing and holding the S button for 2 seconds while in
Surface Mode will activate the ATOM's Receiver and access
a series of screens that will indicate the Status of the system's
Batteries and Pressures of the Tanks in use.
• If a Transmitter is not active and linked to the ATOM, the
message NotAvAil (Not Available) will appear.
• Each screen will be displayed for 3 seconds. ATOM Battery
Status, then Transmitter 1 Battery Status and Tank Pressure,
then Transmitter 2 Battery Status and Tank Pressure, then
Transmitter 3 Battery Status and Tank Pressure.
• The screen will then revert to Surface Mode.
ATOM (Watch) BATTERY STATUS, information includes (Fig. 37):
> Graphic ATOM, refering to the Wrist Watch module
> Graphic bAtt Good (if good), or the Battery icon (if a Low
Battery Warning Condition exists), flashing if Too Low (alarm)
TRANSMITTER STATUS, information includes:
> Graphic TMT1 (or TMT2 or TMT3), identifying the Transmitter
> Graphic bAtt Good (if linked and good) or NotAvAil (Fig.
38), or the Battery icon (if a Low Battery Warning Condition
exists), flashing if Too Low (alarm)
> Tank Pressure (for the Transmitter indicated) and symbol PSI
(or BAR).
To Next Page
Loading...
