Oceanic ATOM - DIVE COMPUTER SET MODES; Set D Group (Dive Data)

45
DIVE COMPUTER SET MODES
Set Mode Sequence:
Surface Mode > SET D > SET A > SET U > SERIAL No. screen.
Access is gained by simultaneous 2 second presses of the A and
S buttons.
Alarms (Set A) and Utilities (Set U) can also be set/changed using
the PC Settings Upload program. Dive Data (Set D) entries must
be made using only the push buttons.
SET D GROUP (DIVE DATA)
Set D Sequence:
SET D > FO2 (GAS 1) > FO2 (GAS 2) > FO2 (GAS 3) > FO2
50% Default > Receiver > Digital Gauge
> The ATOM reverts to the Default Settings when 24 hours
elapse without a dive or after a dive.
> Depressing the A and S buttons simultaneously for 2 seconds
while in the SURFACE MODE will access SET D identified by
the graphic SETD (Fig. 41).
> Pressing and releasing the A button momentarily (< 2 sec-
onds) while SET D is displayed will advance to SET FO2
(GAS 1) with the Set Point flashing.
Fig. 41 - Set D
SET D DEFAULT SETTINGS
FO2 GAS1 > AIR
FO2 GAS2 > AIR
FO2 GAS3 > AIR
FO2 50% DEFAULT > ON
RECEIVER > OFF
DIG GAUGE MODE > OFF