48
Fig. 42 - Set FO2 GAS1
(Air setting)
Fig. 43 - Set FO2 GAS1
(32% setting)
SET FO2 GAS 1 information includes (Fig. 42/43):
> Graphic GAS1
> Max Depth allowed for the PO2 Alarm Set (if 21 to 50%)
> FO2 Set Point value, flashing
> Symbols FO2 and NITROX (if set for a numerical value).
• Depressing and holding the S button while the FO2 Set Point
is flashing will scroll the Set Point from AIR to 21 through 50%
in 1% increments, at a rate of 8 per second.
• Hint: The scroll will stop when the button is released, or
momentarily at 32% (even if the button is held depressed).
• Pressing and holding the S button will resume the scroll from
32 through 50%, then stop at AIR (or 21%).
• Pressing and releasing the S button will advance FO2 in
increments of 1% per press of the button.
• Pressing and releasing the A button momentarily (< 2 sec-
onds) will save the setting and/or advance to SET FO2 GAS
2 with the Set Point flashing.
• Pressing and releasing the A button momentarily and repeat-
edly (< 2 seconds) will step through the other SET D screens.
• Depressing the A and S buttons simultaneously for 2 seconds
will save the setting and revert back to the SET D screen.
• Depressing and holding the M button for 2 seconds will revert
to the Surface Mode screen.
• If no button is pressed during a period of 2 minutes, the unit
will revert to the Surface Mode screen.
To Next Page
Loading...
