61
SET END PRESSURE ALARM information includes (Fig. 58):
> Graphic END
> Set Point numeric value, flashing.
> Symbol PSI (or M)
• Pressing and releasing the S button momentarily (< 2 sec-
onds) will increase the Set Point from 300 to 1,500 PSI (20 to
104 BAR) in 100 PSI (7 BAR) increments.
• Depressing and holding the S button will scroll through the
Set Points at a rate of 4 Set Points per second until it is
released.
• Pressing and releasing the A button momentarily (< 2 sec-
onds) will save the setting and/or advance to the SET PO2
ALARM screen with the Set Point flashing.
• Pressing and releasing the A button momentarily and repeat-
edly (< 2 seconds each time) will step through the other SET A
screens.
• Depressing the A and S buttons simultaneously for 2 seconds
will save the setting and revert back to the SET A screen.
• Depressing and holding the M button for 2 seconds will revert
to the Surface Mode screen.
• If no button is pressed during a period of 2 minutes, the unit
will revert to the Surface Mode screen.
Fig. 58 - Set End Pressure
Alarm
The END PRESSURE
Alarm will activate
when Pressure in the
Tank (TMT 1, 2 , or 3)
being used at the time
decreases to the
Alarm Set Point.
To Next Page
Loading...
