Oceanic ATOM - Page 76

76
SERIAL NUMBER (ATOM)
• Depressing the A and S buttons simultaneously for 8 seconds
while in the SURFACE MODE will access a SERIAL NUMBER
screen.
Information includes (Fig. 70):
> Graphic SN
> Factory programmed Serial Number of the ATOM.
> Firmware revision number (e.g., graphic r1A).
• Depressing the A and S buttons simultaneously for 2 seconds
will revert to the Surface Mode screen.
• Depressing and holding the M button for 2 seconds will revert
to the Surface Mode screen.
• If no button is pressed during a period of 2 minutes, the unit
will revert to the Surface Mode screen.
NOTE: The Serial Number and Firmware Revi-
sion will be requested in the event that you
contact Oceanic regarding the ATOM.
Fig. 70 - Serial Number
(of the Watch)