10-1
10. CHASSIS
EXHAUST SYSTEM ·································· 10-1
SILENCER INSPECTION ····························· 10-1
REAR SEAT ············································· 10-2
CAR ROOF ·············································· 10-3
HANDRAIL ············································· 10-3
SEAT ······················································ 10-4
CAR FRAME ············································ 10-5
EXHAUST SYSTEM
WARNING
Disassemble /install procedures
1、Disassemble vent pipe and silencer 2- connection bolt。
2、Disassemble exhaust pipe and engine 2- joint nut。
3、Disassemble the oxygen sensor from the exhaust pipe
and take out the exhaust pipe.
4、Disassemble silencer from the car frame
5、Disassemble the tailpipe of silencer, take out the fire retardant net.
SILENCER INSPECTION
1、Check the leaks in exhaust pipe and the cracks in
heat insulating shield. 。
2、Check whether the rubber parts in silencer are
cracked or weathered, etc.
3、Clean the sundries and inspect any damage in the
fire retardant net.
If there is any problem, please replace it with a new one.
Be careful not to operate when the engine is running or the silencer is at high temperature.
To Next Page
Loading...