ADVENTURER+ Service Manual P/N 83020790 A
Ohaus Corporation www.ohaus.com 16
3.3 ERROR CODES
This balance is equipped with software which will display an error condition when it occurs. When a problem
occurs using the balance, the display will indicate an error code. Review the listed codes and follow instructions to
correct the problem. Table 3-2 Error Codes, describes the various error codes which can appear on the display
and specifies the probable reason and remedy.
TABLE 3-2 ERROR CODES
Error
Codes
Possible Cause Remedy
Error 7.0
Unstable weight reading when defining the
reference weight.
Eliminate vibration.
Error 8.1
Weight reading exceeds Power On Zero
limit
Clear platform.
Error 8.2 Weight reading below Power On Zero limit. Put platform on balance.
Error 8.3 Weight reading exceeds overload limit. Clear platform.
Error 8.4 Weight reading below underload limit. Put platform on balance.
Error 9.5 Calibration information is error Send the balance back to Ohaus and repaired.
Error 5.3 Can not read EEPROM datum on loadcell.
Repeat to connect or disconnect power.
If can't be remedy, send back to Ohaus.
SYSPTOM PROBABLE CAUSE REMEDY
No Display Power Adapter not connected. Connect Adapter.
Incorrect weight reading.
Balance out of calibration.
Balance was not rezeroed before
weighing.
Calibrate the balance. Press
with no weight on the
pan, then weigh item.
Calibration procedure does not
work.
Incorrect calibration masses being
used.
Use correct masses.
Unable to display weight in a
particular weighing unit.
Weighing unit not activated in menu.
Use Units menu to set desired
units ON (see menu).
Balance won't store selections
made in menu.
YES selection was not used before
exit menu.
You must use YES and then exit
each menu and save selections.
To Next Page