ADVENTURER+ Service Manual P/N 83020790 A
Ohaus Corporation www.ohaus.com 28
Figure 4-6.
Figure 4-6. Adventurer Balance Opened.
4.3.2 Re-assembling the Balance
This procedure is used when the balance has been repaired and all adjustments have been made.
1. Check the interior of the balance and make sure that all connectors are in place and the cables are properly
dressed along the left side wall of the Base. Check all PC boards are secured.
2. Position the Top Cover on top of the Base. Make sure the cover front tabs are in position on the Base.
3. Secure the Top Cover to the Base with the one screw previously removed.
4. For an balance with a Draft Shield:
a) Replace the Draft Shield on top of the Top Cover.
b) Tighten the two screws holding the Draft Shield Bottom.
c) Replace the EMC plate in the Draft Shield.
d) Tighten the two screws holding the EMC plate.
e) Replace Weighing Pan Assembly.
5 For a precision balance without a Draft Shield:
a) Replace the Retaining Ring on top of the Top Cover two exposed screws and turn slightly to lock in
place.
b) Tighten the two screws holding the Retaining Ring.
c) Replace the Sub Platform and weighing Platform.
To Next Page