44
2. If Inter was selected in the Auto Print
submenu, INTER will be displayed
and you may continue with step 3. If
it was not selected, NON-PL will be
displayed. Proceed to step 7.
3. To enter a time interval for automatic
data output, press when
INTER is displayed. The current in-
terval (in seconds) will be displayed.
4. Press
to increase or to
decrease the number.
5. When the desired number is dis-
played, press to accept it.
6. Press once to proceed to step
7, or three times to display END and
proceed to step 15.
7. To enter a range of non printing val-
ues, press
when NON-PL is
displayed. The current value for the
low end of the range will be displayed
with the first digit flashing.
8. To change the number, start with the
first digit (flashing). Repeatedly press
to change the value to any
number from -9 to +9. A minus sign
will light to indicate a negative value.
9. When the desired value is displayed,
press
to accept it and the next
digit will begin flashing.
To exclude dataTo exclude data
To exclude dataTo exclude data
To exclude data
WITHIN SELECTED RANGE:WITHIN SELECTED RANGE:
WITHIN SELECTED RANGE:WITHIN SELECTED RANGE:
WITHIN SELECTED RANGE:
SET non-PL < non-PH
Example:non-PL=7g, non-PH=11g
Values <7
OR OR
OR OR
OR >11 will be output.
To exclude dataTo exclude data
To exclude dataTo exclude data
To exclude data
OUTSIDE SELECTED RANGE:OUTSIDE SELECTED RANGE:
OUTSIDE SELECTED RANGE:OUTSIDE SELECTED RANGE:
OUTSIDE SELECTED RANGE:
Set non-PL > non-PH
Example:non-PL=11g, non-PH=7g
Values >7
AND AND
AND AND
AND <11 will be output.
PRINTPRINT
PRINTPRINT
PRINT
ONON
ONON
ON
TARETARE
TARETARE
TARE
MODEMODE
MODEMODE
MODE
FLASHING
Set time interval from
1 to 256 seconds.
MODEMODE
MODEMODE
MODE
ONON
ONON
ON
TARETARE
TARETARE
TARE
ONON
ONON
ON
TARE TARE
TARE TARE
TARE
MODEMODE
MODEMODE
MODE
ONON
ONON
ON
TARETARE
TARETARE
TARE
To Next Page
Loading...
