Getting started > 30
M
ULTI
PURPOSE
TRAY
1. Open the multi purpose tray (1).
For MB470/MB480: Fold out the paper support (a).
2. Press gently down on the paper platform (2) to ensure it is latched down.
3. Adjust the paper guides (3) to the size of paper being used.
For MB460: Load single sheet at a time in to the Multi purpose tray.
For MB470/MB480: Do not exceed the paper capacity of about 50 sheets or
10 envelopes. Maximum stacking depth is 10mm. Press the tray latch button (4)
inwards to release the paper platform, so that the paper is lifted and gripped in place.
> For single-sided printing on headed paper load the paper into the multi purpose
tray with pre-printed side up and top edge into the MFP.
1
2
a
2
1
3
3
4
To Next Page
Loading...
Need help?
General
