Menu functions > 50
Network
Setup
(cont.)
Gateway
Address
xxx.xxx.xxx.xxx Sets the Gateway (default router) address.
0.0.0.0 means that there is no router.
Display Conditions:
> TCP/IP should be enabled.
> IP Version is not IPv6.
Web Enable
Disable
Sets Enable/Disable of Web.
Enable: Web/IPP is available.
Disable: Web/IPP is not available.
Display Condition: TCP/IP should be enabled.
Telnet Enable
Disable
Sets Enable/Disable of Telnet.
Enable: Telnet is available.
Disable: Telnet is not available.
Display Condition: TCP/IP should be enabled.
FTP Enable
Disable
Sets Enable/Disable of FTP.
Enable: FTP is available.
Disable: FTP is not available.
Display Condition: TCP/IP should be enabled.
IPSec Enable
Disable
Sets Enable/Disable of IPSec. Enable via the web.
Enable: IPSec is available.
Disable: IPSec is not available.
SNMP Enable
Disable
Sets Enable/Disable of SNMP.
Enable: SNMP is available.
Disable: SNMP is not available.
Display Condition: TCP/IP or NetWare should be enabled.
Network
Scale
Normal
Small
When Normal is selected, the network can work
effectively even when it is connected to a HUB that has a
spanning tree feature. However, printer start up time gets
longer when computers are connected with two or three
small LANs.
When Small is selected, computers can cover from two or
three small LANs to a large LAN, but may not work
effectively when the network is connected to a HUB with a
spanning tree feature.
Hub Link
Setting
Auto Negotiate
100Base-TX Full
100Base-TX Half
10Base-T Full
10Base-T Half
Sets a method to link to a HUB. When Auto is set, a
connection method to a HUB is selected automatically and
attempts to connect.
If another method is selected, attempts to connect to a
HUB only by the selected connection method.
Factory
Defaults?
Execute Specifies whether to initialize the network factory default
settings for the Network.
Print Setup Personality Auto
PostScript
PCL
Selects a printer language.
Copies 1- 999 Selects the number of copies.
This setting is disabled for Local Print except for Demo
Page.
Media Check Enable
Disable
Sets whether the printer checks the matching of printed
data size and that of the tray. Only standard sizes are
checked.
ITEM SETTINGS EXPLANATION