Menu functions > 49
A
DMIN
SETUP
ITEM SETTINGS EXPLANATION
Enter
Password
xxxxxxxxxxxx Enter a password to gain entry to the Admin Setup menu.
Password should be from 6 to 12 digits of alpha/numeric
characters (or mix)
The default value is “aaaaaa”
Network
Setup
TCP/IP Enable
Disable
Sets TCP/IP Protocol.
Enable: TCP/IP Protocol is available.
Disable: TCP/IP Protocol is not available.
IP Version IP v4
IP v4+v6
IP v6
Set up the IP version.
Operates with IPv4 for IPv4 (not valid with IPv6).
Operates with both IPv4 and IPv6 for IPv4+v6.
Operates with IPv6 for IPv6 (not valid with IPv4).
There is only IPv4 and IPv4+v6 as normal value.
From this stage, if IPv6 only is set from UI, for example
Telnet, “IPv6” appears as the value of IP Version on the
operation panel. “IPv6” will disappear from the value if “IP
v4” or “IP v4+v6” is selected.
Display Condition: TCP/IP should be enabled.
NetBEUI Enable
Disable
Sets Enable/Disable of NETBEUI Protocol.
NetBIOS
over TCP
Enable
Disable
Sets Enable/Disable of NetBIOS over TCP protocol.
Display Conditions:
> TCP/IP should be enabled.
> IP Version is not IPv6.
NetWare Enable
Disable
Sets Enable/Disable of NetWare Protocol.
EtherTalk Enable
Disable
Sets Enable/Disable of EtherTalk Protocol.
Frame Type Auto
802.2
802.3
Ethernet II
SNAP
Sets the frame type.
Display Condition: Netware should be enabled.
IP Address
Set
Auto
Manual
Sets the IP Address setting method.
Display Conditions:
> TCP/IP should be enabled.
> IP Version is not IPv6.
IPv4
Address
xxx.xxx.xxx.xxx Sets the IP Address.
Display Conditions:
> TCP/IP should be enabled.
> IP Version is not IPv6.
Subnet Mask xxx.xxx.xxx.xxx Sets the Subnet Mask.
Display Conditions:
> TCP/IP should be enabled.
> IP Version is not IPv6.