Menu functions > 51
Print Setup
(cont.)
Resolution 600dpi
600x1200dpi
600dpi multi-
level
Sets default resolution.
X Dimension 64 mm
~
210 mm
~
216 mm
Specifies paper width of Custom paper as a default value.
Sets a paper size at right angles to the paper run
direction.
Y Dimension 127 mm
~
297 mm
~
1321 mm
Specifies paper length of Custom paper as a default value.
Sets a paper size in the same direction as the paper run
direction.
PS Setup Network
Protocol
ASCII/RAW Specifies PS communication protocol mode of data from
NIC port.
(In RAW mode, Ctrl-T is invalid). PS models only.
Parallel
Protocol
ASCII/RAW Specifies PS communication protocol mode of data from
Centronics port.
(In RAW mode, Ctrl-T is invalid). PS models only.
USB
Protocol
ASCII/RAW Specifies PS communication protocol mode of data from
USB port.
(In RAW mode, Ctrl-T is invalid). PS models only.
Color Setup CMY 100%
Density
Enable/Disable Enable/Disable 100% output against the CMY100% TRC
compensation. Ordinarily, the TRC compensation function
holds control for the appropriate print density; thus 100%
output is not always possible.
Selecting ENABLE will enable 100% output in any
individual color. The actual print, including the TRC
compensation function is limited to an appropriate area.
This function is for special purposes such as specification
in CMY color reduction in PS.
Memory
Setup
Receive
Buffer Size
Auto
0.5 megabyte
1 megabyte
2 megabyte
4 megabyte
8 megabyte
16 megabyte
32 megabyte
Sets the size of receive buffer
Resource
Save
Auto
Off
0.5 megabyte
1 megabyte
2 megabyte
4 megabyte
8 megabyte
16 megabyte
32 megabyte
Sets the size of resource saving area.
ITEM SETTINGS EXPLANATION