Oki C911 - Page 37

- 37 -
If paper messages are displayed
Troubleshooting
1
2
IndexMaintenance
Category
Message displayed on the
liquid crystal panel
Error
code
<ATTENTION>
lamp
Causes and Troubleshooting
Paper size
Error
Remove Excess Paper and Reset Tray
[TRAY]
Please see HELP for details
530
531
532
533
534
Blinking The paper in the tray may exceed the
maximum limit, or the paper tray may
need to be reset.
Please remove paper from the tray
shown.
Check Paper in [TRAY]
Paper Thick Error
Please see HELP for details
323
324
325
326
Blinking In the tray shown in the message,
paper of a different thickness is
detected.
To cancel printing, press the [CANCEL]
button. If multiple errors occur, you
can not cancel printing.
Press the [HELP] button, and solve
according to the guidance shown on
the Help screen.
Check Paper in [TRAY]
Paper Multi Feed
Please see HELP for details
401 Blinking Multiple sheets of paper have been fed.
To cancel printing, press the [CANCEL]
button. If multiple errors occur, you
can not cancel printing.
Press the [HELP] button, and solve
according to the guidance shown on
the Help screen.
Check Paper in [TRAY]
Paper Size Error
Please see HELP for details
400 Blinking Printing has been conducted on paper
which is of a different size from the
specications of the printer driver.
To cancel printing, press the [CANCEL]
button. If multiple errors occur, you
can not cancel printing.
Press the [HELP] button, and solve
according to the guidance shown on
the Help screen.
Reset Tray
[TRAY]
Please see HELP for details
520
521
522
523
524
Blinking Paper cannot be fed from the tray
shown in the message.
Reset the paper in the tray shown in
the message.