Oki C911 - Page 39

- 39 -
If replace consumables messages are displayed
Troubleshooting
1
2
IndexMaintenance
Category
Message displayed on the
liquid crystal panel
Error
code
<ATTENTION>
lamp
Causes and
Troubleshooting
Reference
pages
Image
Drum
Install [COLOR] New Image Drum
Printing disabled due to low
threshold of Image Drum life
Please see HELP for details
6800
6801
6802
6803
6804
6805
Blinking The lifespan of the image drum
has been reached.
You cannot continue printing.
Press the [HELP] button, and
solve according to the guidance
shown on the Help screen.
page 66
Check Image Drum
[COLOR]
Please see HELP for details
3400
3401
3402
3403
3404
3405
Blinking Image drum shown in the
message has not been set
correctly.
Press the [HELP] button, and
solve according to the guidance
shown on the Help screen.
-
Waste
Toner Box
Install New Waste Toner Box
Waste Toner Full
Please see HELP for details
357 Blinking Waste toner is full.
If you re-set and use a waste
toner box that is already used,
there is a risk of the waste toner
overowing, so please replace it
with a new waste toner box.
Press the [HELP] button, and
solve according to the guidance
shown on the Help screen.
page 77
Fuser Unit Install New Fuser Unit
Fuser Unit Life
Please see HELP for details
354 Blinking Lifespan of the fuser unit has
reached
Press the [HELP] button, and
solve according to the guidance
shown on the Help screen.
page 75
Belt Unit Install New Belt Unit
Belt Unit Life
Please see HELP for details
355 Blinking Lifespan of the belt unit and
the transfer roller unit has been
reached.
Press the [HELP] button, and
solve according to the guidance
shown on the Help screen.
page 69
- Caution, unknown Consumable
detected
Go to User Manual "Trouble
Shooting" to restore operation
709 Blinking You can use any consumables
in your product, but you must
accept the risks of using non-
genuine consumables. If the use
of non-genuine consumables
causes damage to the product
or results in your product
not functioning to its full
specication, then such damage
or effect on the product is not
covered by warranty. To accept
these risks and to restore
function;
1. Turn off your product.
2. Press and hold the [CANCEL]
button and turn your product
on.
3. After start up, release the
[CANCEL] button.
Note
This operation will be recorded
for future reference.
-