Oki C911 - Page 43

- 43 -
If other messages are displayed
Troubleshooting
1
2
IndexMaintenance
Message displayed on the
liquid crystal panel
Error
code
<ATTENTION>
lamp
Causes and Troubleshooting
Reference
pages
Check Fuser Unit
Please see HELP for details
348
320
Blinking The fuser unit is not installed
correctly.
Install the fuser unit correctly.
-
Receiving Data Timeout
Press OK Button for Restoration
Please see HELP for details
519 Blinking A data receipt timeout occurred.
Increase the length of timeout print
setting.
[Advanced] >
[List of Setting
Items of
the Device
Settings
Screen] >
[Timeout
Printing]
Check Data
Message Data Write Error <[CODE]>
- - Failed to write the message data to
be updated. Check data.
-
Install Transfer Roller Unit
Re-set the transfer roller unit
Please see HELP for details
334 Blinking The transfer roller unit is not set
correctly.
Press the [HELP] button, and solve
according to the guidance shown on
the Help screen.
-
A spot color printing error has
occurred. Data will be erased
Check the paper and paper
settings, then print again. To turn
off the display, press OK
Please see HELP for details
459 Blinking
Because of a print request for paper
unavailable to spot color printing, the
printing has been stopped, and the
data was deleted.
Check the paper and paper settings,
and print again.
Press the [OK] button for deleting the
display of the liquid crystal panel.
-
The data will be deleted due to an
overprint feature error
Mount the duplex printing unit
and print again. To turn off the
display, press OK
Please see HELP for details
458 Blinking
Spot Color over printing is specied,
but the 2-Sided Printing unit is not
there. Printing was stopped and the
print data was deleted.
Install the 2-Sided Printing unit and
print once again.
Press the [OK] button for deleting the
display of the liquid crystal panel.
(C941/ES9541/Pro9541 only)
-
The data will be deleted due to an
overprint feature error
Check the paper and paper
settings, then print again. To turn
off the display, press OK
Please see HELP for details
456 Blinking Paper used for printing is not
compatible for Spot Color over
printing. Printing was stopped and
the print data was deleted.
Change the paper, or set to Normal
and print once again.
Press the [OK] button for deleting the
display of the liquid crystal panel.
(C941/ES9541/Pro9541 only)
-
Spot Color has been replaced
Press OK to change the Spot Color
settings in the menu to [COLOR]
and restart the system
If you do not want to change
settings, return Spot Color toner,
image drum and Spot Color duct
settings to [MENUCOLOR].
679 Blinking Spot Color has been exchanged
Solve according to the message.
(C941/ES9541/Pro9541 only)
-
Spot Color has been replaced
Check Spot Color menu settings
Current setting is [MENUCOLOR]
Press OK Button
678 Blinking Spot Color has been exchanged
Solve according to the message.
(C941/ES9541/Pro9541 only)
-
Spot Color settings changes
Shut down and restart to enable
new settings
677 Blinking
Spot Color setting has been
changed.
Solve according to the message.
(C941/ES9541/Pro9541 only)
-