Oki C911 - Page 45

- 45 -
If other messages are displayed
Troubleshooting
1
2
IndexMaintenance
Message displayed on the
liquid crystal panel
Error
code
<ATTENTION>
lamp
Causes and Troubleshooting
Reference
pages
Firmware Update Error
Please retry
If network doesn’t work, please
try rmware update over USB
302 - Firmware update failed.
Follow the contents of the message.
-
Open Stacker
Face Up Stacker
Please see HELP for details
580 Blinking Face up stacker is closed.
Please open the face up stacker.
-
Belt Unit Not Installed
Please see HELP for details
689 Blinking The belt unit is not installed.
Press the [HELP] button, and solve
according to the guidance shown on
the Help screen.
-
Check Belt Unit
Please see HELP for details
330 Blinking The belt unit is not set correctly.
Press the [HELP] button, and solve
according to the guidance shown on
the Help screen.
-
Power Off and Wait for a while
126: Condensing Error
- Blinking Condensation has occurred inside
the printer.
Restart the printer after some time.
If the error is not resolved by
restarting the printer, contact your
designated help desk.
-
Install Duplex Unit
Please see HELP for details
360 Blinking The 2-Sided Printing unit is not set
correctly.
Install the 2-Sided Printing unit
correctly.
-
The data was deleted because a
duplex printing error occurred
Check the paper and paper
settings, then print again. To turn
off the display, press OK
Please see HELP for details
455 Blinking
2-Sided printing cannot be done
because the paper is too thick or it is
small. Printing was stopped and the
print data was deleted.
Change the paper, or set to 1-Sided
Printing and print once again.
Press the [OK] button for deleting
the display of the liquid crystal panel.
-