Oki C9650hdn - Menus Example 1 - Tray 1 Transparencies

Appendix B – menu system > 122
M ENUS EXAMPLE 1 – TRAY 1 TRANSPARENCIES
To print on transparencies (accommodated in Tray1):
1. Ensure that the LCD panel indicates that the printer is
ready to print.
2. Enter menu mode by pressing either the Up-arrow or
Down-arrow button and press them repeatedly as
required until the MENUS MENU is highlighted.
3. Press the Enter button to select this menu.
4. Press the Up-arrow or Down-arrow buttons repeatedly
until
TRAY CONFIGURATION is highlighted.
5. Press the Enter button to select this Item.
6. Press the Up-arrow or Down-arrow buttons repeatedly
until
TRAY1 CONFIG is highlighted.
7. Press the Enter button to select this Item.
8. Press the Up-arrow or Down-arrow buttons repeatedly
until
MEDIATYPE is highlighted.
9. Press the Enter button to select this Item.
10. Press the Up-arrow or Down-arrow buttons repeatedly
to move through the range of media types until
TRANSPARENCY is highlighted.
11. Press the Enter button to select this value.
12. Check that an asterisk (*) appears beside
TRANSPARENCY.
13. Press the Online button to exit menu mode and return to
the ready to print status.