Installing upgrades > 132
8. Start WPS-PBC (push button) on the wireless terminal (computer, tablet,
smartphone, etc.).
Manual connections
If the wireless terminal (computer, tablet, smartphone, etc.) does not support WPS-PBC
(push button), then you can input the machine's SSID and password into the wireless
terminal (computer, tablet, smartphone, etc.) to connect.
Follow the procedure below to connect.
1. Turn on the printer.
2. Press up or down on the operator panel to display Wireless(AP Mode) Setting,
and then press the OK button.
3. Enter the Admin password and then press the OK button.
(The default password is 999999.)
4. Select Enable, and then press the OK button.
5. Press up or down on the operator panel to display Manual Setup, and then press
the OK button.
6. Confirm the SSID and Password that are displayed on the printer.
7. Input the priner’s SSID and Password that were confirmed in step 6 for the
wireless terminal (computer, tablet, smartphone, etc.).
To Next Page
Loading...
