How do I stop junk faxes on my Oki All in One Printer?
To block junk faxes on your Oki All in One Printer, press the (SETTING) button on the operator panel and select [Admin Setup] > [Fax Setup] > [Other Settings] > [Block Junk Fax List] > Set [Setting] to [Mode1].
What to do if no wireless devices are connected to my Oki All in One Printer?
If no wireless devices are connected to your Oki All in One Printer: * Make sure that [Wireless(AP Mode)] on the machine is set to [Enable]. * Confirm the SSID/password for the machine and try Manual Setup. * Make a setting in a location near the machine with good visibility. * Note that up to four devices can be connected to the machine via the wireless LAN (AP mode). The fifth device will be rejected. Disconnect at least one device and try again.
What should I do if the communication quality is low and the fax may not have received correctly on my Oki All in One Printer?
If the communication quality is low and a fax may not have been received correctly on your Oki All in One Printer, turn off the super G3 mode. If there is still a problem in the received fax, contact the other party and have them resend it.
General| Functions | Print, Copy, Scan, Fax |
|---|---|
| Print Technology | LED |
| Fax Modem Speed | 33.6 kbps |
| Monthly Duty Cycle | Up to 45, 000 pages |
| Duplex Printing | Yes |
| Weight | 29 kg |
| Print Resolution | 1200 x 1200 dpi |
| Scan Resolution | Up to 600 x 600 dpi |
| Connectivity | USB 2.0, Ethernet, Wireless |
| Paper Capacity | 250 sheets (standard tray) |
To Next Page
