3
Align the side guides to the paper length,
and push the blue set button.
4
Press [MPT] on the touch panel.
5
Press [ZOOM] on the touch panel.
6
Press [CUSTOM PAPER] on the touch
panel.
7
Key in the dimension.
1) Press [Length] and key in the value. (127mm to
356mm)
2) Press [Width] and key in the value. (64mm to 216mm)
3) Press [OK].
Length and width are indicated as shown on the right:
To call up the dimension data registered previously, press
the desired button from [MEMORY 1] to [MEMORY 4],
and then press [OK].
Memo
• To register dimension data into the memory, see the
following page:
P.42 "Registering non-standard size in the memory"
8
Select other copy modes as required, and
then press the [START] button on the
control panel.
To Next Page
Loading...
