16. Three items factor into printhead gap information.
1. Printhead Gap Adjustment (performed by a service technician)
2. Printhead Gap Adjust (set in the printer menu, under the Set-up Group)
3. Gap Control (set in the printer menu, under each [Paper Feed] Group)
A. True
B. False
Correct Answer: A
Page C-1, Service Handbook, Rev 01 and 02 OLD QUESTION
Pages 1-12 and 2-18, Service Handbook, Rev 03 NEW QUESTION
17. Which of the following areas of the printer should NOT be lubricated?
1. Tractor pins
2. Pressure roller (Rubber Face)
3. Platen assembly (Rubber Face)
4. Teeth of gears in the gear case assembly
A. 1
B. 1 and 2
C. 1, 2, and 3
D. 1, 2, 3, and 4
Correct Answer: D
Page 3-88 and 3-89, Service Handbook, Rev 01 and 02
Page 3-91, Service Handbook, Rev 03
Course Administration i - 22 Microline 520/521 Service Handbook
P/N 59257803
To Next Page
Loading...
