18. You are performing the printhead gap adjustment. The printhead gap is changed by
turning the adjusting screw, located on the space motor assembly. Turning the
adjusting screw counter-clockwise will increase the gap. Turning it clockwise will
decrease the gap.
A. True
B. False
Correct Answer: B
Page 3-68, Service Handbook, Rev 01 and 02
Page 3-68, Service Handbook, Rev 03
19. The ALARM lamp is flashing. The 15 cpi LED is lit. Which of the following should be
replaced first?
A. Printhead
B. Line feed motor
C. Space motor
D. Main control board and / or ROM
Correct Answer: D
Page 4-30, Service Handbook, Rev 01 and 02
Page 4-20, Service Handbook, Rev 03
Microline 520/521 Service Handbook i - 23 Course Administration
P/N 59257803
To Next Page
Loading...
