Oki Microline 8480 FB - Manual Feed Configuration

Microline 8480FB User’s Guide
The Function Setting Menu • 38
Manual Feed
Manual Feed Cross Ref.
TOF 2.12 mm (1/12”), 3.18 mm
(1/8”),
6.35 mm (1/4”) , 7.62
mm (3/10”), 8.47 mm (1/3”),
10.58 mm (5/12”), 23.28 mm
(11/12”), 25.4 mm (1”), 27.52
mm (13/12”), 1Chr. Set Pos.
Note: 1Chr. Set Pos. automatically
appears as the setting when the
front panel has been used to set a
1Chr. Set Pos value for the Manual
Feed path (see page 58).
Wait Time
Auto Alignment
must be disabled to
use Wait Time
.
2.0 sec , 1.5 sec, 1.0 sec, 0.5 sec
Load LF Speed
Fast Speed , Slow Speed
Eject Dir.
Front , Rear
Paper End
On-line , Off-line
Gap Control
Auto , Manual Gap x
x = 1 - 8, A - E (see page 66)
Gap Pos. 50.8 mm (2”) , 101.6 mm (4”)
Auto Align (POW) Align 1, Align 2, Align 3, Align 4,
Select Align
Auto Align
Align 1 , Align 2, Align 3, Align 4,
Invalid
MemoryAutoAlign
Valid , Invalid
Align1 Pos.Adj.
(Align 1 must be
selected)
0 mm,
5.1 mm , 45.4 mm
Adjusts in 1/90 inch (0.28 mm)
increments from initial setting
Align2 Pos.Adj.
(Align 2 must be
selected)
0 mm,
5.1 mm , 45.4 mm
Adjusts in 1/90 inch (0.28 mm)
increments from initial setting
Align3 Pos.Adj.
(Align 3 must be
selected)
0 mm, 5.1 mm , 45.4 mm
Adjusts in 1/90 inch (0.28 mm)
increments from initial setting
Align4 Pos.Adj.
(Align 4 must be
selected)
0 mm,
5.1 mm , 45.4 mm
Adjusts in 1/90 inch (0.28 mm)
increments from initial setting
AutoAlignDetect Valid Level 1,
Valid Level 2 ,
Invalid
Group Item Settings