Oki Microline 8480FB

Microline 8480FB User’s Guide
• 53
Manual feed settings: 2.12 mm (1/12"), 3.18 mm (1/8"), 6.35
mm (1/4"), 7.62 mm (3/10"), 8.47 mm (1/3")*, 10.58 mm
(5/12"), 23.28 mm (11/12"), 25.4 mm (1"), 27.52 mm (13/12"),
1 Chr. Set Pos.
Continuous form settings: 2.12 mm (1/12”), 3.18 mm (1/8”),
6.35 mm (1/4”), 8.47 mm (1/3”)*, 10.58 mm (5/12”), 19.05 mm
(9/12”), 23.28 mm (11/12”), 25.4 mm (1”), 27.52 mm (13/12”),
1 Chr. Set Pos.
* When 1/3-inch is selected, the distance is from the top of the
page to the top of the first print line, not the vertical middle.
TOF Adj. (Cut)
For fine tuning the Top of Form (TOF) location when using manual
feed from the platform. Settable from -40 to +40 in increments of
1/120 inch. The default is 0.
Negative values decrease the space down from the top of the
form:
•TOF moves up
•paper moves down.
Positive numbers increase the space down from the top of the
form:
•TOF moves down
•paper moves up.
Wait Time
Note Auto Alignment (see page 41) must be disabled to use Wait
Time.
Choose the amount of time the printer waits for paper to be
inserted after print data is received when you are using manual
feed from the platform: 2.0 sec [the default], 1.5 sec, 1.0 sec,
or 0.5 sec.
Zero Character
The default is Unslashed. Change to Slashed if you wish to use a
slash to distinguish the number zero from the capital letter 0.