Oki Microline 8480FB

Microline 8480FB User’s Guide
Tests • 63
Tests
Rolling ASCII Test
Note When the printer is running a test, it always uses a left
margin of 5.1 mm (0.2-inch).
This test provides a one-page continuous printout of the ASCII
characters.
1. Turn off the printer.
2. Simultaneously press and hold the LF and FF switches while
turning on the printer.
3. Load a sheet of paper on the platform.
4. The Rolling ASCII test will run and the sheet will eject.
Font Sample Test
Note When the printer is running a test, it always uses a left
margin of 5.1 mm (0.2-inch).
This test provides a sample of each of the available fonts in the
printer.
Note The Font Sample test takes two letter-size sheets.
1. Turn off the printer.
2. Simultaneously press and hold the MODE and LF switches while
turning on the printer.
3. Load a sheet of paper on the platform.
4. The Font Sample test will run and the sheet will eject.
5. Remove the first printed sheet from the platform and load
another sheet.
6. The test finishes printing and the sheet ejects.