Oki Microline 8480FB

Microline 8480FB User’s Guide
Setting the Printhead Gap • 68
4. Press and hold SHIFT, then press FF repeatedly until MANUAL
FEED
displays.
5. Press FF repeatedly until
GAP CONTROL displays.
6. Press MODE repeatedly until the desired printhead gap setting
appears on the display.
7. Press and hold SHIFT, then press FF repeatedly until
FRONT
FEED
displays.
8. Press FF repeatedly until
GAP CONTROL displays.
9. Press MODE repeatedly until the desired printhead gap setting
appears on the display.
10. Press LOAD: this saves your setting and exits the menu mode.
SHIFT + FF.jpg
FF.JPG
MODE.JPG
SHIFT + FF.jpg.JPG
FF.JPG
MODE.JPG
LOAD.JPG