Oki MPS5501B User Manual

- 52 -
Adding a Printer With the LPD Protocol (TCP/IP)
2
Printing Basic Operation
●● Adding a Printer With the LPD Protocol (TCP/IP)
In MAC OS X environment, you can connect a PS printer with the LPD protocol (TCP/IP).
Note
● If your printer does not support the TCP/IP protocol, you cannot connect a printer with this method. Check whether your
printer can be connected to the network with the TCP/IP protocol or not.
Preparations
1 Check that the IP address, subnet
mask, rooter address, etc, for the target
Macintosh are set correctly and it is
connected to the network with the TCP/
IP.
2 Download the PPD installer for MAC OS X
of the PS printer to be connected from
OKI Data homepage, and unzip it. Then
start the PPD installer to install the PPD
on the Macintosh. If the PPD has been
installed, this step is not required.
3 Set the IP address, subnet mask,
gateway address, etc. on a PS printer
to be connected. Keep the power of
the printer on for the printer being
connected to the TCP/IP network.
Procedures for Adding a
Printer
1 Open the System Preferences of
Macintosh, click [Print & Scan] to open
the [Print & Scan] dialog box.
2 Click [+] to open the [Add] dialog box.

Oki MPS5501B Specifications

General

Print Speed	55 ppm
Resolution	1200 x 1200 dpi
Standard Paper Capacity	630 sheets
Connectivity	USB 2.0, Ethernet
Max Paper Size	A4
Maximum Paper Capacity	3160 sheets