Olimpia splendid 02234 - Description of Unit; List of Supplied Components; Storage; Receipt and Unpacking

MAESTRO PRO INVERTER
US-ENGLISH
US-ENG- 5
1 - DESCRIPTION OF UNIT
1.1 - LIST OF SUPPLIED COMPONENTS (Fig.1)
Thepartslistedbelowandshowningure1areincludedinthesupply,theotherparticularsnecessaryfor
installationmustbepurchased.
A. MAESTRO PRO
B. Remote control
C. Use and maintenance manuals & warranty doc
D. Strip of adhesive insulation tape (x 2)
E. Air intake and discharge external grilles includ-
ing anchoring kit for installing the grilles (x 2)
F. Internalanges(x2)
G. Flexible wall sleeves (x 2)
H. Kit of screws and anchor bolts
L. Wall mounting bracket
M. Installation template
N. Condensate drain tube
O. Puricationlter(green)
P. Activecarbonlter(black)
1.2 - STORAGE
Store units in an area protected from outdoor ambient conditions. Units should be stored on pallets or beams
to isolate from the ground.
DO NOT TURN THE PACKAGING UPSIDE DOWN OR LAY IT DOWN/PLACING IT ON ITS SIDE.
1.3 - RECEIPT AND UNPACKING
Theproductsarepackagedbyqualiedpersonnelusingsuitablepackagingmaterial.Theunitsareshipped
complete and in perfect condition when leaving our facility. However, we suggest that you perform the
following checks:
a. Upon receipt check if the package is damaged. If damage is found note this on the shipping documents
taking photographs of any damage. Notify the shipper by registered mail with 3 days of receipt.
b. Unpack and check the contents against the packing list.
c. Check that none of the components have been damaged during transport; if damage is found notify the
shipper by registered letter, which should include photographic evidence within 3 days of receiving the
unit.
d. Send the same information by fax to OLIMPIA SPLENDID.
e. No claims for damage will be accepted if made more than 3 days after the delivery of the goods.
It is recommended to keep the packaging during the warranty period for any
possible delivery of the product to a service center. After the warranty period
ends dispose of the packaging in compliance with prevailing regulations.