Olimpia splendid SILENT 10 P - Trouble Shooting Guide

ENGLISH
EN - 34
6 - TROUBLE SHOOTING GUIDE
Do not try to repair the appliance by yourself.
Iftheproblemhasnotbeensolved,pleasecontactyourlocalretailerortheclosestassistanceservice.
Supplydetailedinformationaboutthemalfunctionandtheequipmentversion.
CAUSE
• Nopower.
• Theplughasnotbeeninserted.
• TimerisON
• Thetemperaturesetistoocloseto
ambient temperature.
• Suctionofoutsideairisobstructed.
• Windowopen.
• Somesourceofheatisoperatinginthe
room (burner, lamps, etc.) or the room
is crowded.
• Thetemperaturesetistoohigh.
• Thepoweroftheconditionerisnot
suitable for ambient conditions or
dimensions.
• Theconditionerhasbeentiltedorlaid
 at.
• Thelterisdirty
• Roomtemperaturesensor
• Evaporatingfanmotor
• Excessiveaccumulationofwaterinside
air conditioner
• Ambienttemperaturetoolow
• Ambienttemperaturetoolowortoohigh
WHAT DO I DO?
• Wait.
• Plugintheconditioner.
• Switchoffthetimer
• Lowerthetemperatureset.
• Removetheobstructions.
• CalltheServiceCenter.
• Closethewindow.
• Eliminatesourcesofheat.
• Lowerthetemperatureset.
• Remove the plug (24) and drain the
water before moving the conditioner.
• Cleanthelter
• Switch the appliance back on and
press button SW7 on the control panel
for 5 seconds so that the alarm signal
disappears from the display.
• CalltheServiceCentre.
• CalltheServiceCentre.
• Drain thewaterbyremovingthecap
(24). Contact the service centre if this
alarm occurs too frequently.
HP: this alarm is normal when heating
without a water drain pipe installed.
• Airconditionerbehaviourisnormal.
• Airconditionerbehaviourisnormal.
MALFUNCTION
• Theconditionerdoesnotwork.
• Theconditionerworksonlyfora
short period.
• Theconditionerworksbutdoesnot
refresh the room.
• Waterleaksfromtheconditioner
during transport.
• Alarmsignal“Fi“appearsonthecontrol
panel display
• Theconditionerswitchesoff,thecontrols
on the remote control and the control
panel do not respond and alarm signal
“2”ashesonthecontrolpaneldisplay.
• Theconditionerswitchesoff,thecontrols
on the remote control and the control
panel do not respond and alarm signal
“8”ashesonthecontrolpaneldisplay.
• Theairconditionerisoff,thenumber“3”
ashesonthecontrolpaneldisplayand
the red LED is on.
• Incooling,night-timeorautomaticmode,
minimum speed cannot be selected.
• Inheatingmode(HPonly)theaircon-
ditioner stops the compressor or the
external fan cyclically for a few minutes.