Safety philosophy
The control system fulls stringent safety require-
ments in terms of reliability and operational safety.
The controller and radio decoder contains radio
modules, FCC ID: MCQ-XBSX and IC: 1846A-
XBSX.
The radio devices complies with part 15 of FCC
rules and ICES-003.
Olsbergs radio remote control system has been
developed to provide operators with continual
feedback via its displays on the hand controller.
The hand controller’s standard menu selection
system utilises the displays to provide the oper-
ator with real time information about the chosen
menu, battery status, reception conditions etc.
The hand controller contains a two-way communi-
cation radio enabling information to be sent both to
it and from it. The radio decoder contains a corre-
sponding unit to handle trafc at the other end.
The hand controller utilises 915 Mhz radio with max.
e.r.p of 22 mW, which is operating in the ISM 902–
928 Mhz frequency band, a free band approved
by the Federal Communications Commission, and
Industry Canada.
Introduction
3
- This means that no license is needed and the radio
can in principle be used everywhere in north
America including over national boundaries. For
detailed information about free band use see
www.fcc.gov and www.ic.gc.ca
The side displays show the symbol for the function
each lever activates in the chosen menu. When the
operator changes menu, the symbols change to the
functions that become active.
The centre display provides information about which
menu has been chosen, as well as indicating the
radio reception conditions, battery status, fault infor-
mation, micro, manual extension and so on. Further-
more information about VSL+ and stability diagram
is displayed in the centre display.
Technical description
To Next Page
Loading...
General