EasyManua.ls Logo

Olympus BF-UC180F - Page 91

Olympus BF-UC180F
183 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
84
Chapter 7 Cleaning, Disinfection, and Sterilization Procedures
ULTRASONIC BRONCHOFIBERVIDEOSCOPE BF-UC180F
Reprocessing equipment parts and functions
For inspection of other equipment than that mentioned below, refer to the
instruction manual for the equipment being used.
Water-resistant cap (MH-553)
The water-resistant caps are attached to the videoscope scope cable connector
and the ultrasonic cable connector on the endoscope to protect the connectors
from water penetration during reprocessing. For leakage testing, the venting
connector on the water-resistant cap must be connected to the leakage tester
(MB-155) (see Figure 7.2).
Figure 7.2
Suction cleaning adapter (MAJ-222)
The suction cleaning adapter is used to aspirate reprocessing fluids from the
distal end of the endoscope through the instrument channel and the suction
channels (see Figure 7.3).
Figure 7.3
Groove
Seal
Venting connector
Suction opening
Suction
cylinder cap
Port cap

Table of Contents

Other manuals for Olympus BF-UC180F

Related product manuals