Olympus bx40 - Mounting Filter Cassette 34835; Using Filter Cassette

BX40
Fig. 34
| Using the Filter Cassette (option) (Figs. 33, 34, 35, 36) |
If you need to place 3 or more filters over the light exit window, use the
filter cassette.
Loading Filters Into the Filter Cassette (Fig. 33)
The filter cassette has two filter levers on the right side and one on the
left side.
The filter cassette accommodetes filters with a diameter of 45 mm and
a thickness of 2.7 mm or less.
1. Move all filter levers to the OUT position except for the one belonging
to the slot inte which the filter is to be inserted.
2. Slide lever a to the IN position. Make sure that it clicks securely into
place.
3. Holding the lever in the position shown, put the filter into the cassette
by inserting it in the direction indicated by the arrow.
4. Place the other two filters in the same manner
| Mounting the Filter Cassette (Figs. 34, 35) |
1. Loosen the filter cassette clamping screw @. (Fig. 39)
Holding the filter cassette above the light exit glass, align the key @
with the slot © and press the filter cassette into place from above
. Rotate the filter cassette to align its sides with the base. (Fig. 40)
4. Align the clamping screw @ with the positioning hole © on the light
exit, then tighten the screw to fasten the filter cassette
* When the filter cassette is installed, the stage may hit it when
lowered. Therefore, exercise caution when lowering the stage
with the filter cassette installed.
n
©
Fig. 36
pe [Using the Filter Cassette (Fig. 36) |
Usable filters Applications
45LBD-IF Color balancing filter
45ND-6, 45ND-25 Neutral density filter
456-530, 45G-533, 451F550 Green
45Y-48 Yellow B7W contrast filter
450-560 | Orange
45С-3, 45KB-3 Daylight filter
Table 1
Up to three of the above filters can be inserted into the filter cassette.
Moving the levers @ on the left and right sides of the cassette to the
IN position moves the corresponding filter into the light path.
SIOHLNOD
3HL
9NISn
А