Olympus bx40 - Attach the Specimen Holder

BX40
a
Install
the
Halogen
Bulb
(Figs.
3,
4)
The
bulb
used
in
this
microscope
is
a
6V,
30WHAL
halogen
bulb
(Phillips
5761)
1.
Holding
the
bulb
@
with
gloves
or
a
piece
of
gauze,
insert
the
bulb
pins
©)
into
the
pin
holes
@.
(Fig.
3)
*
Do
not
touch
the
bulb
with
your
fingers.
If
you
accidentally
get
fingerprints
on
the
bulb,
wipe
it
with
a
piece
of
soft
cloth.
2.
Align
the
guide
pins
©
with
the
guide
pin
slots
©
and
the
plug
©
with
the
socket
©),
gently
push
the
illuminator
into
place.
(Fig.
4)
*
Whenever
you
replace
the
bulb,
first
turn
off
the
power
switch
and
wait
for
bulb
and
lamp
socket
to
cool.
Attach
the
Stage
(Fig.
5)
1, Fully loosen the clamping screw @ on the stage.
2. Carefully lower the stage into the round sleeve on the substage, then
tighten the clamping screw.
Attach the Specimen Holder (Fig. 6)
Loosen the specimen holder clamping screws @ without exposing
the threads.
* Be careful to avoid loosening the specimen holder clamping
screws too much. If you loosen the screws too much, the threads
will prevent complete insertion of the specimen holder.
Align the slot in the specimen holder with the clamping screws, then
slide the specimen holder backwards as far as it will go.
* Slide the specimen holder all the way back or it will not be
positioned properly.
. Tighten the specimen holder clamping screws.
AlaWwassy
B