Olympus bx40 - Stage Height Adjustment 42843

Fig. 42
BX40
Rotating
the
Stage
(Fig.
41)
1. Slightly loosen the stage clamping screw @.
2. The stage can be rotated by turning it with the stage clamping screw.
+ The rotation angle changes depending on position of the stage knobs.
Rotation angle
Clockwise г
Right hand knobs 230° 20°
Left hand knobs 20° 230°
Table 2
Stage
Height
Adjustment
(Figs.
42,
43)
By lowering the stage height, the microscope will accommodate specimens
with height up to 40 mm. This is useful when observing metallurgical
specimens and other thick objects.
1. Lower the stage to the lower limit, then remove the stage from the
microscope. (See page 43)
2. Loosen the stage bracket clamping screw @ and remove the stag
bracket. (Fig. 42)
3. Turn the coarse adjustment knob and raise the focusing block @) te
where the stopper screw @ in the arm becomes visible. (Fig. 43)
4. Using the Allen wrench, loosen and remove the upper stopper seren
©.
5. Reattach stage bracket and stage.
Store the removed stopper screw @ in a safe place so that you da nc
lose it.
13
STOYLNOD
3HL
DNISN
a