Olympus bx40 - Connect the Power Cord; Replace Fuses

BX40
Fig. 12
When using the trinocular observation tube (U-TR30) or super-wide-
field trinocular observation tube (U-SWTR)
When using a finder eyepiece or an eyepiece with diopter adjustment,
inset it into the right-hand eyepiece sleeve. When doing so, make sure
that the eyepiece positioning pin @ fits into the notch @ at the bottom
of the eyepiece sleeve. (Fig. 11)
di Connect the Power Cord (Fig. 12)
1. Check that the power switch (D is in the OFF position.
2. Before shipment from the factory, the voltage selector switch @ is
set to the 200-240V position. In case your local line voltage is 100-
120V, move the lever to the 100-120V position using a flat-blade
screwdriver.
3. Plug the power cord into the receptance ©.
4. Connect the power cord's ground wire to the earth terminal on the
power outlet you will be using with the microscope, then plug the
Power cord into the wall outlet.
Replace Fuses (Figs. 13, 14)
Before replacing fuses, turn off the power switch and unplug the power
cord.
1. Remove the fuse holder @ by squeezing it at the sides and pulling
outward, (Fig. 13)
2. Replace both fuses @ with new ones. (Fig. 14)
* Use only fuses of the specified rating.
Fuse rating: 250V, 2A, 2 fuses
(LITTEL FUSE 218002)
人
18WSSV
В