82
Remote control shooting
5
Advanced shooting
TIPS
The self-timer remote control lamp does not blink after pressing
the shutter button on the remote control device.
Æ The remote control device may be too far from the camera. Move
closer to the camera and press the shutter button on the remote
control device again.
Æ The remote control batteries are exhausted. Replace with new
batteries. g “How to replace the battery (CR2025) of the remote
control device” (P.171)
How to cancel the remote control mode.
Æ The remote control mode is not canceled automatically after
shooting. Perform step 2 and set the mode to OFF (no display).
• If the remote control receiver is exposed to strong light, the effective
signal distance may be reduced or shooting may not take place.
Note
To Next Page
Loading...
