Editing still pictures (ADD FRAME/BLACK & WHITE/SEPIA/Q)
68
5
Playback
Sound can be added to a still picture that you have already taken. (This is known as
“after-recording”.) You can also re-record over the sound that has already been
recorded. Total recording time per picture is approximately 4 seconds.
Select the still picture to which you want to add sound, and display the top menu.
Top menu [MODE MENU] [PLAY] [R]
g“How to use the menus” (P. 16)
1 Press d to display [START].
2 Aim the camera microphone
toward the sound you want to
record, and press Z to start
recording.
• The [BUSY] bar is displayed during
recording.
Adding sound to still pictures
Note
• If the microphone is farther than 1 m (3.3 ft.) from the subject, sound may not
be recorded properly.
• If you re-record the sound, the original sound is erased.
• You cannot record sound when there is insufficient space in the internal
memory or card.
• The microphone may pick up the sound of buttons operated.
• Once sound is added to a picture, it is not possible to erase only the sound. In
this case, make a re-recording with silence.
EDITMEM
SET
PLAY
START
<
R
Microphone
To Next Page
Loading...
