184
9
Troubleshooting (Cont.)
POSSIBLE CAUSES CORRECTIVE ACTION
REF. PAGE
No picture is taken when the Shutter button is pressed.
5 There is a problem with the
card.
6 The card is full.
7 The batteries ran out.
8 The viewfinder/monitor
indications disappear, or only
the battery check blinks.
9 A write-protect adhesive seal
is placed on the card or there
is no card in the camera.
5 See the Error code chart.
6 Replace the card or delete
unwanted pictures, etc.
7 Replace the batteries with new
ones.
8 Replace the batteries with new
ones. (Do not open the Battery
compartment cover when the
Card access lamp is blinking.)
9 Insert a new card in the camera.
P. 189
P. 26, 39
P. 23
P. 16, 23
P. 23
The date recorded with the image data is wrong.
1 The date was not set.
2The camera has been left for
approx. 1 hour with the
batteries removed and the
date setting is canceled.
1 Set the date. The clock
adjustment is not factory-preset.
2 Try setting the date again.
P. 29
P. 29
1 The flash is pushed down.
2 The subject is lighted.
3 The sequential mode is set to
, or . The Mode
dial is set to .
1 Press the Flash switch to raise
the flash.
2 Set the flash to Fill-In mode.
3 Press the DRIVE button to set to
the single-frame mode.
Set the mode dial to any position
other than .
P. 36, 77
P. 72, 75
P. 46, 63
The flash does not fire.
Pictures you have already taken do not appear on the monitor.
1 The camera is in the
shooting mode.
2 There is no picture in the
card.
3 There is a problem with the
card.
1 Set the Mode dial to .
2 NO PICTURE appears on the
monitor. Record pictures.
3 See the Error code chart.
P. 54
P. 35, 190
P. 189,
190
To Next Page
Loading...
