185
9
POSSIBLE CAUSES CORRECTIVE ACTION
REF. PAGE
Pictures you have already taken do not appear on the monitor.
4 The camera is connected to
a TV.
5 The monitor is not on.
4 The monitor does not function
when the camera is connected to
a TV.
5 Press to turn on the monitor.
P. 55
P. 37
Troubleshooting (Cont.)
The viewfinder display is not clear.
1 The diopter is not adjusted
properly.
2 The brightness is not
adjusted properly.
1 Adjust the diopter again.
2 Adjust the brightness.
P. 33
P. 129
Picture rotate, Picture protect, Single-frame erase,
All-frame erase, Print reserve and Card formatting cannot be performed.
1 A write-protect adhesive seal
is affixed to the card.
1 Use the card after peeling off the
seal. Do not reuse the write
protect seal.
The monitor is not clear.
1 The brightness is not
adjusted properly.
2 The monitor is exposed to
direct sunlight.
1 Adjust the brightness.
2 Block the sunlight.
P. 129
P. 25
When the camera is connected to a computer,
an error message appears while data is being transferred to the computer.
1 The cable is not plugged in
correctly.
2 The power is off.
3 The batteries are exhausted.
4 The USB driver is not
installed properly.
1 Connect the cable correctly.
2 Turn on the power, then set the
Mode dial to .
3 Replace the batteries with new
ones or use the optional AC
adapter.
4 Try installing the USB driver
again. Confirm that the computer
recognizes the camera.
P. 164
P. 165
P. 23, 176
P. 164–
167
To Next Page
Loading...
